Seat Back Recliner Replacement - Front (With RPO Code YC7)

SEAT BACK RECLINER REPLACEMENT - FRONT (WITH RPO CODE YC7)

REMOVAL PROCEDURE
1. Remove the bucket seat from the riser.
2. Remove the armrest from the recliner side of the seat.
3. Remove the J-hooks that retain the carpet on the back of the seat cushion to the corners of the seat cushion trim cover.
4. Remove the screw that retains the seat back recliner handle to the recliner.




5. Remove the bolts that retain the recliner to the seat back and seat cushion frames.

IMPORTANT: When removing the bolts that retain the seat back recliner, note the position and length of the bolts. This will assist with reassembly.

6. Remove the seat back recliner from the seat frame.

IMPORTANT: Handle the seat carefully when just one side of the seat back is attached to the seat cushion. Improper handling may damage the seat back hinge or the lumbar support cable.

INSTALLATION PROCEDURE
1. Install the seat back recliner to the seat frame.




2. Install the seat back bolts that retain the recliner to the seat back and the seat cushion frame.
3. Install the seat back bolts in the locations noted during disassembly.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the seat back bolts that retain the recliner to the seat back and the seat cushion frames to 30 Nm (22 lb ft).

4. Install the screw that retains the seat back recliner handle to the seat back recliner.

Tighten the screw that retains the seat back recliner handle to the seat back recliner to 2 Nm (18 lb in).

5. Install the J-hooks that retain the carpet to the seat back and to seat cushion frame and to the corners of the seat cushion cover.
6. Install the armrest to the seat back recliner side of the seat.
7. Install the bucket seat to the riser.