Brake Light Switch: Service and Repair

STOP LAMP SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the battery negative cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




2. Remove the retainer (3) from the brake pedal pin.
3. Unsnap the switch (2) and pushrod (4) from the brake pedal (1) pin.




4. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Connect the electrical connector.




2. Install the switch (2) and pushrod (4) onto the brake pedal (1) pin.
3. Install the retainer (3) onto the brake pedal (1) pin.
4. Connect the battery negative cable.