Console Replacement - Overhead (Full Length)
CONSOLE REPLACEMENT - OVERHEAD (FULL LENGTH)
REMOVAL PROCEDURE
1. Remove the overhead lamp lens on the overhead console.
2. Remove the 3 overhead console roof screws. One screw is located towards the front of the console and the other 2 are located behind the dome lamp lens.
3. Disconnect the electrical connectors.
4. Remove the console.
INSTALLATION PROCEDURE
1. Install the console to the roof.
2. Connect the electrical connectors.
3. Install the overhead console to the roof with the three roof screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the overhead console screws to 2 N.m (18 lb in).