39. Balancer Shaft Bearing Removal

Balance Shaft Bearing and/or Bushing Removal

^ Tools Required
- J 26941 Bushing/Bearing Remover
- J 38834 Balance Shaft Service Kit





1. Caution: Refer to Safety Glasses Caution in Service Precautions.

Use the J 38834 and the J 26941 in order to remove the balance shaft rear bearing.
1. Install J 26941 legs behind the balance shaft rear bearing and secure.
2. Install the J 38834-1 with the short threaded end through the balance shaft bore in the front of the engine block.
3. Install the J 38834-1 into J 26941.
4. Slide the J 38834-2 onto the J 38834-1 and into the balance shaft bore of the engine block.
5. Install the J 38834 bearing, washer, and nut onto the J 38834-1.
6. Using a wrench secure the J 38834-1 and then rotate the J 38834 nut clockwise until the balance shaft rear bearing is removed from the engine block.
7. Remove the J 26941 from the balance shaft rear bearing.
2. Discard the balance shaft rear bearing.