Balance Shaft: Service and Repair
Balance Shaft Replacement
^ Tools Required
- J 8092 Universal Driver Handle
- J 36996 Balance Shaft Installer
- J 45059 Angle Meter
Removal Procedure
1. Remove the radiator.
2. Remove the A/C condenser.
3. Remove the valve lifter pushrod guide.
4. Remove the timing chain and camshaft sprockets.
5. Remove the balance shaft drive gear.
6. Important: The balance shaft drive and balance shaft driven gears are serviced as a set. The set includes the balance shaft driven gear bolt.
Remove the balance shaft driven gear bolt from the balance shaft.
1. Use a wrench in order to secure the balance shaft. Place the wrench onto the balance shaft near to the balance shaft front bearing.
2. Remove the balance shaft bolt.
3. Remove the wrench from the balance shaft.
7. Remove the balance shaft driven gear from the balance shaft.
8. Remove the bolts and the balance shaft retainer.
9. Important: The balance shaft and the balance shaft front bearing are serviced only as a package. Do not remove the balance shaft front bearing from the balance shaft.
Use a soft-faced hammer in order to remove the balance shaft from the engine block.
10. Clean and inspect the balance shaft.
Installation Procedure
1. Important: The balance shaft and the balance shaft front bearing are serviced only as an assembly. Do not remove the balance shaft front bearing from the balance shaft.
Apply clean engine oil GM P/N 12345610 (Canadian P/N 993193) or equivalent to the balance shaft front bearing.
2. Use the J 36996 and the J 8092 in order to install the balance shaft.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the balance shaft retainer and bolts.
^ Tighten the bolts to 12 Nm (106 inch lbs.).
4. Install the balance shaft driven gear onto the balance shaft.
5. If reusing the fastener, apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the balance shaft driven gear bolt.
6. Install the balance shaft driven gear bolt.
1. Use a wrench to secure the balance shaft. Place the wrench onto the balance shaft near to the balance shaft front bearing.
2. Install the balance shaft driven gear bolt.
^ Tighten the balance shaft driven gear bolt to 20 Nm (15 ft. lbs.). Using the J 45059, rotate the balance shaft driven gear bolt an additional 35 degrees.
7. Remove the wrench from the balance shaft.
8. Rotate the balance shaft by hand in order to ensure that there is clearance between the balance shaft and the valve lifter pushrod guide. If the balance shaft does not rotate freely, check to ensure that the retaining ring on the balance shaft front bearing is seated on the case.
9. Install the balance shaft drive gear. DO NOT install the camshaft sprocket bolts at this time.
10. Rotate the engine camshaft so that the timing mark on the balance shaft drive gear is in the 12 o'clock position.
11. Remove the balance shaft drive gear.
12. Rotate the balance shaft so that the timing mark on the balance shaft driven gear is in the 6 o'clock position.
13. Position the balance shaft drive gear onto the engine camshaft.
14. Look to ensure that the balance shaft drive gear and the balance shaft driven gear timing marks are aligned.
15. Install the timing chain and the camshaft sprocket.
16. Install the engine front cover.
17. Install the valve lifter pushrod guide.
18. Install the A/C condenser.
19. Install the radiator.