Steering Wheel Control Switch

Steering Wheel Control Switch Assembly Replacement

Removal Procedure

1. Caution: Refer to SIR Caution in Service Precautions.

Disable the Restraints system.
2. Remove the inflator module.





3. Remove the screws (1) which retain the horn contact plate to the steering wheel.





4. Remove the two screws (1) which retain the control button assembly (2) to the steering wheel.





5. Disconnect the electrical connector (2) from the control button assembly (1).

Installation Procedure





1. Connect the electrical connector (2) to the control button assembly (1).





2. Notice: Refer to Fastener Notice in Service Precautions.

Install the control button assembly (2) to the steering wheel with the two screws (1).
^ Tighten the screws to 1.5 Nm (13 inch lbs.).





3. Install the horn contact plate to the steering wheel with the screws (1).
^ Tighten the screws to 5.5 Nm (50 inch lbs.).
4. Install the inflator module.
5. Enable the Restraints system.