Lower

Lower Control Arm Replacement (RWD)

Removal Procedure





1. Remove the front coil spring.
2. Remove the lower ball joint from the steering knuckle.
3. Remove the lower control arm from the vehicle.
4. Remove the lower control arm bumper nut.
5. Remove the lower control arm bumper.
6. Inspect the lower ball joint for wear, replace as necessary.

Installation Procedure





1. Install the lower control arm bumper.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the lower control arm bumper nut
^ Tighten the nut to 25 Nm (18 ft. lbs.).
3. Install the lower control arm to the vehicle.
4. Install the lower ball joint stud to the steering knuckle.
5. Install the front coil spring.
6. Check the front wheel alignment. Adjust if necessary.