Seat Replacement - Bench

SEAT REPLACEMENT - BENCH

REMOVAL PROCEDURE




1. Disconnect the battery negative cable in the power seat only.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the seat adjuster trim covers.
3. Disconnect the electrical connectors, if equipped.
4. Remove the seat mounting nuts.
5. Remove the seat mounting bolts.
6. Guide the seat belts through the slots in the seat. Remove the seat from the vehicle.

INSTALLATION PROCEDURE




1. Guide the seat belts through the slots in the seat. Install the seat to the vehicle.
2. Install the seat mounting bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the seat mounting bolts to 70 N.m (52 lb ft).

3. Install the seat mounting nuts.

Tighten the seat mounting nuts to 45 N.m (33 lb ft).

4. Connect the electrical connectors, if equipped.
5. Install the seat adjuster trim covers.
6. Connect the battery negative cable.