Seat Replacement - Bucket

SEAT REPLACEMENT - BUCKET

REMOVAL PROCEDURE
1. Remove the seat adjuster trim covers.




2. Remove 3 seat mounting nuts.
3. Remove the seat mounting bolt.
4. Disconnect the electrical connectors from seat if necessary.
5. Remove the seat from the vehicle.

INSTALLATION PROCEDURE
1. Position the seat on the 3 seat mounting studs on the floor of the vehicle.




2. Install the seat mounting bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the seat mounting bolt to 70 N.m (52 lb ft).

Install the seat mounting nuts.

Tighten the seat mounting nuts to 45 N.m (33 lb ft).

3. Install the seat adjuster trim covers.