Oil Pump: Service and Repair

Oil Pump Replacement

Removal Procedure





1. Remove the oil pan.
2. Remove the oil pump bolt.





3. Remove the oil pump.





4. Inspect the pins (oil pump locator) for damage, and replace the pins if required.
5. Clean and inspect all parts.

Installation Procedure





1. Inspect for properly installed pins (oil pump locator).





2. Important: Do not reuse the oil pump driveshaft retainer.

During assembly, install a NEW oil pump driveshaft retainer.
Install the oil pump.
3. Position the oil pump onto the pins.





4. Notice: Refer to Fastener Notice in Service Precautions.

Install the oil pump bolt attaching the oil pump to the rear crankshaft bearing cap.
^ Tighten the oil pump bolt to 90 Nm (66 ft. lbs.).
5. Install the oil pan.