Operation CHARM: Car repair manuals for everyone.

68. Engine Front Cover Installation



Engine Front Cover Installation





1. Important: Once the composite engine front cover is removed DO NOT reinstall the engine front cover. Always install a NEW engine front cover.

Install the NEW engine front cover.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the engine front cover bolts.
^ Tighten the bolts to 12 Nm (106 inch lbs.).





3. Important: DO NOT reuse the original crankshaft position sensor seal, O-ring. When installing the crankshaft position sensor be sure the crankshaft position sensor is fully seated and held stationary in the engine front cover crankshaft position sensor bore. A crankshaft position sensor that is not completely seated will cock in the engine front cover and may result in erratic engine operation.

Lubricate the NEW crankshaft position sensor seal, O-ring, with clean engine oil.
4. Install the NEW crankshaft position sensor seal, O-ring, onto the crankshaft position sensor.





5. Install crankshaft position sensor until fully seated into the engine front cover.
6. Install crankshaft position sensor bolt.
^ Tighten the crankshaft position sensor bolt to 8 Nm (71 inch lbs.).