NVG 233-NP1 Transfer Case

Transfer Case Speed Sensor Replacement

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.
3. Remove the front propeller shaft.
4. Remove the transfer case speed sensor electrical connector.





5. Remove the transfer case speed sensor.

Installation Procedure





1. Notice: Refer to Fastener Notice in Service Precautions.

Install the transfer case speed sensor.
^ Tighten the transfer case speed sensor to 15 Nm (11 ft. lbs.).





2. Install the transfer case speed sensor electrical connector.
3. Install the front propeller shaft.
4. Install the transfer case shield to the vehicle.
5. Lower the vehicle. Refer to Vehicle Lifting.