NVG 236-NP8 Transfer Case

Transfer Case Motor/Encoder Replacement

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield from the vehicle.





3. Remove the motor/encoder electrical connector.





4. Remove the motor/encoder mounting bolts.
5. Remove the motor/encoder assembly.
6. Remove the motor/encoder gasket.

Installation Procedure





1. Important: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper installation.

Install the motor/encoder to the transfer case.
2. Install the motor/encoder gasket to the transfer case.

Notice: Refer to Fastener Notice in Service Precautions.

Install motor/encoder mounting bolts to the transfer case.
^ Tighten the motor/encoder mounting bolts to 20 Nm (15 ft. lbs.).





3. Install the motor/encoder electrical connector.
4. Install the transfer case shield.
5. Lower the vehicle. Refer to Vehicle Lifting.