Underhood Electrical Center or Junction Block Replacement

UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the battery negative cable.




2. Remove the battery positive cable cover.




3. Remove the battery positive cable bolt.
4. Remove the battery positive cable from the underhood electrical center.




5. Remove the bolts that attach the underhood electrical center to the underhood electrical center support bracket.




6. Loosen the bolts that secure the electrical connectors to the bottom of the underhood electrical center.




7. Disconnect the electrical connectors from the underhood electrical center .
8. Remove the underhood electrical center from the vehicle.

INSTALLATION PROCEDURE




1. Connect the electrical connectors to the underhood electrical center.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the electrical connector to the underhood electrical center bolts to 7 N.m (62 lb in).




2. Install the bolts that attach the underhood electrical center to the underhood electrical center support bracket.

Tighten the underhood fuse block to the underhood electrical center support bracket bolts to 7 N.m (62 lb in).




3. Attach the battery positive cable with bolt to the underhood electrical center.

Tighten the battery positive cable to the underhood electrical center bolt to 10 N.m (89 lb in).




4. Replace the battery positive cable cover.
5. Connect battery negative cable.