2-Door Utility

Stabilizer Shaft Replacement (2-Door Utility)

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the following parts from the stabilizer links:
^ The lower nuts
^ The washers
^ The bolts





3. Remove the nuts from the U-bolts.
4. Remove the following parts:
^ The U-bolts
^ The clamps
^ The insulators
5. Remove the stabilizer shaft.

Installation Procedure





1. Install the stabilizer shaft to the rear axle.
2. Install the following parts:
^ The insulators
^ The clamps
^ The U-bolts

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the nuts to the U-bolts.
^ Tighten the nuts to 60 Nm (44 ft. lbs.).





4. Install the stabilizer shaft to the link mounting bolt.
5. Install the stabilizer shaft to the link nut.
^ Tighten the link nut to 68 Nm (50 ft. lbs.).
6. Lower the vehicle.