Four-Wheel Drive Indicator Switch Replacement

Four-Wheel Drive Indicator Switch Replacement

Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the front differential carrier shield, if equipped.





3. Disconnect the electrical harness from the four-wheel drive indicator switch.





4. Remove the four-wheel drive indicator switch.

Installation Procedure





Notice: Refer to Fastener Notice in Service Precautions.

1. Install the four-wheel drive indicator switch.
Tighten the four-wheel drive indicator switch to 5 Nm (44 inch lbs.).





2. Install the electrical harness from the four-wheel drive indicator switch.
3. Install the front differential carrier shield if equipped.
4. Lower the vehicle.