Allison

Park/Neutral Position Switch Adjustment
^ Tools Required
- J 41364-A PNP Switch Adjusting Tool

Caution: Refer to Battery Disconnect Caution in Service Precautions.





1. Make sure the selector shaft is in the N (Neutral) position as follows:
^ Place a wrench on the selector shaft flats and rotate the shaft to its furthest clockwise position.
^ Rotate the selector shaft counter-clockwise two detents.





2. Be sure that J 41364-A (2) is in the proper position on PNP switch (1).
3. While maintaining the correct PNP switch-to-selector-shaft alignment, slide the new PNP switch (5) over the selector shaft (4).

Notice: Refer to Component Fastener Tightening Notice in Service Precautions.

4. While holding J 41364-A in engagement with the PNP switch, install the two bolts (6) so that the PNP switch may be rotated with some effort.
^ Tighten the two bolts (6) to 27 Nm (20 lb ft).
5. Remove J 41364-A.





6. Install splash shield (1), concave side toward PNP switch (3), over selector shaft (2).





Notice: Refer to Transmission Selector Shaft Abuse Notice in Service Precautions.

7. Reinstall shift lever (2). Install nut (3), by hand, on the end of selector shaft (4). Use a wrench (1) to keep the shift lever from rotating.
^ Tighten nut (3) to 24 Nm (18 lb ft).
8. Reconnect the shift selector linkage/cable to the shift lever (2).
9. Connect the external wiring harness to the PNP switch.