Ignition Lock Cylinder Case

Ignition Lock Cylinder Case Replacement

Caution: Refer to SIR Caution in the Preface section.

1. Disable the SIR system.
2. Remove the ignition switch.
3. Remove the turn signal cancel arm.
4. Remove the park lock cable from the lock cylinder housing.






5. Remove 3 TORX screws.
6. Remove the lock cylinder housing from the steering column.

Installation Procedure

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.






1. Install 3 TORX screws into the lock cylinder housing.

Tighten
Tighten the TORX screws to 7 Nm (62 lb in).

2. Install the turn signal cancel cam.
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch.
5. Enable the SIR system.
6. Refer to Control Module References for programming and setup information. Programming and Relearning