Camshaft Position (CMP) Actuator Solenoid Valve Replacement

Camshaft Position Actuator Solenoid Valve Replacement

Removal Procedure

^ Remove the drive belt. Refer to Drive Belt Replacement.
^ Remove the 3 power steering pump bolts and move the pump out of the way.
^ Disconnect the camshaft position actuator solenoid electrical connector.





^ Remove the camshaft position actuator solenoid retaining bolt (3).
^ Remove the camshaft position actuator solenoid (2) from the engine block.
^ Clean debris from the hole (1).

Installation Procedure

^ Lubricate the hole (1) with engine oil.

Notice: Refer to Fastener Notice in the Preface section.





^ Install the camshaft position actuator solenoid (2) and bolt (3).

Tighten
Tighten the bolt to 10 N.m (89 lb in).

^ Connect the camshaft position actuator solenoid electrical connector.
^ Install the power steering pump and bolts.
^ Install the drive belt.