Turn Signal Switch: Service and Repair

Multifunction Turn Signal Switch Housing Replacement
Removal Procedure





1. Caution: Refer to Restraint Systems Caution in Service Precautions.

Disable the Restraint Systems. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
2. Remove the steering wheel from the column.
3. Remove the ignition lock cylinder case assembly.
4. Remove the turn signal and multifunction switch assembly.
5. Slide the turn signal switch housing off of the steering column shaft assembly.

Installation Procedure





1. Important: The turn signal switch housing must be pressed firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly screws to line up.

Slide the turn signal switch housing onto the steering column shaft assembly.
2. Install the turn signal and multifunction switch assembly.
3. Install the ignition lock cylinder case.
4. Install the steering wheel onto the column.
5. Enable the Restraint Systems. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.