Cable Guide Bracket Replacement - Sliding Door

Rear Side Door Actuator Cable Guide Bracket Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
2. Remove the right rear quarter lower trim panel. Refer to Trim Panel Replacement - Rear Quarter - Right (Trim Panel Replacement - Rear Quarter - Right) in Interior Trim.
3. Release the cable tension:

1. Push the tensioning nut inward.
2. Pull the rear cable until the cable is slack.

4. Visually confirm that the cables are slack by observing that the center white dots are below the white indicator bands.
5. Remove the right rear tail lamp assembly. Refer to Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement in Lighting Systems.




6. Remove the cable guide bracket screws.
7. Remove the cable guide bracket from the vehicle.
8. Slide the guide bracket pulley cover off of the pulley and lift the rear cable off of the guide bracket pulley.



Installation Procedure

1. Slide the guide bracket pulley cover off of the pulley and lift the rear cable off of the guide bracket pulley.




2. Install the cable guide bracket to the vehicle.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the cable guide bracket screws in the correct fastener tightening sequence as shown.

Tighten the screws to 10 N.m (89 lb in).

4. Install the right rear tail lamp. Refer to Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement in Lighting Systems.
5. Position the center roller bracket at the front of the track, 25 mm (1 in) away from the forward radius of the center track to where the cable tension slot is accessible in the window.
6. Insert a 97 mm (3/8 in) drill bit into the tension slot on the actuator motor.
7. Adjust the cable tension by turning the cable adjuster nut counterclockwise until the tensioner pins are located between both the front and rear double blocks. The blocks are marked on the Power Sliding Door (PAD) module housing.
8. Remove the 97 mm (3/8 in) drill bit from the cable tension slot.
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
10. Perform the reinitialization procedure. Refer to Power Sliding Door (PSD) Re-Initialization Power Sliding Door (PSD) - Re-Initialization
11. Install the right rear quarter lower trim panel. Refer to Trim Panel Replacement - Rear Quarter - Right (Trim Panel Replacement - Rear Quarter - Right) in Interior Trim.