Body Control Module: Service and Repair

BODY CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE
1. Rotate the ignition switch to the OFF position.




2. Remove the radio bezel.
3. Disconnect the body control module (BCM) electrical harnesses.
4. Remove the BCM from the instrument panel (I/P) retainer:
1. Pry the BCM tabs from the locking tabs on the underside of the restraint.
2. Slide the BCM out of the retainer.

INSTALLATION PROCEDURE




1. Install the BCM.
2. Install the radio bezel.
3. Slide the BCM tabs into the slots in the I/P retainer until the tabs lock into place.
4. Connect the electrical connectors.
5. Program a new or a remanufactured BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration. Programming and Relearning