Fog/Driving Lamp Switch: Service and Repair

FOG LAMP SWITCH REPLACEMENT - FRONT

REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) trim bezel from the center stack.




2. Remove the screw that retains the center air deflector assembly to the I/P trim bezel. Remove the air deflector assembly.




3. Use a flat-bladed tool to release the fasteners on the fog lamp switch.




4. Disconnect the electrical connector and remove the fog lamp switch.

INSTALLATION PROCEDURE




1. Align the fog lamp switch with the center air deflector assembly and snap into place.




2. Install the center air deflector assembly to the I/P trim bezel.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 2.5 N.m (22 lb in).




3. Connect the electrical connector to the fog lamp switch.
4. Install the I/P trim bezel.
5. Test the fog lamp switch for proper operation.