Accessory Power Receptacle Replacement - 12 Volt - Rear Quarter Trim

ACCESSORY POWER RECEPTACLE REPLACEMENT - 12 VOLT - REAR QUARTER TRIM

TOOLS REQUIRED
J 42059 Cigar Lighter Socket Remover

REMOVAL PROCEDURE
1. Remove the fuse located in the instrument panel (I/P) fuse block.
2. Lift the tether cap and locate 2 square holes in the receptacle.




3. Hold J 42059 at a 30 degree angle as you insert the tool into the receptacle.
4. Position one side of the tool in each hole.




5. Pull the receptacle straight out.
6. Disconnect the connector and remove the receptacle.

INSTALLATION PROCEDURE




1. Connect the receptacle connector.
2. Push the receptacle into the side trim.
3. Install the fuse.