Operation CHARM: Car repair manuals for everyone.

P1682



DTC P1682

CIRCUIT DESCRIPTION
The throttle actuator control (TAC) system uses an ignition voltage supply separate from the engine control module (ECM) supply. If the ECM detects a voltage difference between the two circuits, this DTC will set.

DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC P1682 Ignition 1 Switch Circuit 2

CONDITIONS FOR RUNNING THE DTC
- The ignition is ON.
- DTC P1682 runs continuously when the above condition is met.

CONDITIONS FOR SETTING THE DTC
- The ignition 1 voltage is less than 10 volts.
- The above condition is present for more than 1.6 seconds.

ACTION TAKEN WHEN THE DTC SETS
- The control module stores the DTC information into memory when the diagnostic runs and fails.
- The malfunction indicator lamp (MIL) will not illuminate.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
- The driver information center, if equipped, may display a message.

CONDITIONS FOR CLEARING THE DTC
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.

TEST

Step 1 - Step 10:




Step 11 - Step 17: