Knee Bolster Replacement - Left

KNEE BOLSTER REPLACEMENT - LEFT

REMOVAL PROCEDURE
1. Remove the left instrument panel (I/P) trim panel.




2. Remove 3 screws (1) retaining the knee bolster to the instrument panel.




3. Disconnect the electrical connector (2) from the headlamp switch.

INSTALLATION PROCEDURE




1. Connect the electrical (2) connector to the headlamp switch.




2. Install the 3 screws (1) retaining the knee bolster to the I/P.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 2.5 N.m (22 lb in).

3. Install the left I/P trim panel.