Folding Top Stowage Compartment Lid Extension Panel Replacement

FOLDING TOP STOWAGE COMPARTMENT LID EXTENSION PANEL REPLACEMENT

REMOVAL PROCEDURE




1. Cycle the folding top to its open position.
2. Stop the cycle before the folding top stowage compartment lid closes.
3. Place a protective cover over the adjacent body panels.




4. Using a grease pencil or suitable marking device, mark the extension panel hinges to the folding top stowage lid for realignment.
5. Remove the extension panel hydraulic cylinder.
6. Lay the extension panel cylinders on the protective cover.




7. Remove the stowage compartment extension panel hinge fasteners.




8. Remove the stowage compartment extension panel from the vehicle.
9. If replacing the stowage compartment extension panel, perform the following:
1. Remove the extension panel weatherstrips.
2. Remove the extension lid hinge.

INSTALLATION PROCEDURE
1. If replacing the stowage compartment extension panel, perform the following:
1. Install the extension panel weatherstrips.
2. Install the extension lid hinge.




2. Install the stowage compartment extension panel to the vehicle.




3. Install the stowage compartment extension panel fasteners. Hand tighten the fasteners.
4. Align the stowage compartment extension panel hinges to the alignment marks.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the stowage compartment extension panel fasteners to 10 N.m (88 lb in).

5. Install the extension panel hydraulic cylinder.
6. Remove the protective covering from the vehicle.
7. Cycle the folding top and inspect for proper operation. Refer to Power Folding Top Description and Operation.
8. Cycle the folding top to the closed position.