Folding Top Stowage Compartment Lid Extension Panel Weatherstrip Replacement - Front/Rear

FOLDING TOP STOWAGE COMPARTMENT LID EXTENSION PANEL WEATHERSTRIP REPLACEMENT - FRONT/REAR

TOOLS REQUIRED
J 38778 Door Trim Pad Clip Remover

FRONT REMOVAL PROCEDURE




1. Cycle the folding top stowage compartment lid open.
2. Stop the cycle when the folding top is fully retracted into the stowage compartment area.




3. Using the J 38778, remove the weatherstrip attaching retainers.
4. Remove the weatherstrip from the vehicle.

FRONT INSTALLATION PROCEDURE




1. Align the weatherstrip to the stowage compartment extension panel.
2. Install the weatherstrip attaching retainers.
3. Push firmly on the weatherstrip retainers to fully seat the attaching retainers.
4. Cycle the folding top closed.

REAR REMOVAL PROCEDURE
1. Remove the extension panel from the vehicle.




2. Heat the extension lid panel using a heat gun. Hold the heat gun approximately 152 mm (6 in) from the surface. Apply the heat in a circular motion for about 30 seconds.




3. Pull upward to remove the weatherstrip from the extension panel.
4. Remove all adhesive from the extension panel using Varnish Makers and Painters (VMP) naptha.

REAR INSTALLATION PROCEDURE
1. Ensure the painted surface of the extension panel is clean and dry.
2. Warm the extension panel with a heat lamp or heat gun to a minimum of 21°C (70°F).




3. Align the weatherstrip to the extension panel.
4. Pull the backing from the weatherstrip.

IMPORTANT: Do not touch the adhesive backing.

5. Press the weatherstrip to the extension panel.
6. Hand roll the weatherstrip to the extension panel in order to ensure proper adhesion.
7. Install the extension panel to the vehicle.
8. Inspect the folding top for proper operation.