Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the generator mounting bracket.
2. Remove the camshaft position sensor mounting bolts (1).
3. Remove the camshaft position sensor assembly (4, 5, 6) from the front cover assembly (7).
4. Disconnect the camshaft position sensor jumper harness (2) and the engine harness (3) electrical connectors.
5. Separate the camshaft sensor (5) and O-ring (6) from the jumper harness (4). Discard the O-ring and use NEW only.

INSTALLATION PROCEDURE




1. Apply a small amount of clean motor oil to the O-ring (6).
2. Install the NEW O-ring (6) on the camshaft sensor (5).
3. Reconnect camshaft sensor (5) and (6) to the jumper harness (4).
4. Reconnect the engine harness connector (3) to the jumper harness (2).
5. Install the camshaft sensor assembly (4, 5, 6) to the front cover (7).
6. Install the mounting bolts (1) for the camshaft sensor (5).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the mounting bolts (1) to 25 N.m (18 lb ft).

7. Install the generator mounting bracket.