Quick Connect Fitting(s) Service (Metal Collar)

QUICK CONNECT FITTING(S) SERVICE (METAL COLLAR)

TOOL REQUIRED
J 37088-A Tool Set, Fuel Line Quick-Connect Separator

REMOVAL PROCEDURE
1. Relieve the fuel system pressure before servicing any fuel system connection. Refer to the Fuel Pressure Relief Procedure.
2. Remove the retainer from the quick-connect fitting.




3. Blow dirt out of the fitting using compressed air.

CAUTION: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.




4. Choose the correct tool from the J 37088-A tool set for the size of the fitting. Insert the tool into the female connector, then push inward in order to release the locking tabs.




5. Pull the connection apart.
6. Use a clean shop towel in order to wipe off the male pipe end.

NOTE: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.

7. Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.

INSTALLATION PROCEDURE




1. Apply a few drops of clean engine oil to the male pipe end.

CAUTION: Refer to Fuel Pipe Fitting Caution in Service Precautions.




2. Push both sides of the fitting together in order to snap the retaining tabs into place.




3. Once installed, pull on both sides of the fitting in order to make sure the connection is secure.
4. Install the retainer to the quick-connect fitting.