Inflatable Restraint Side Impact Module Replacement - Front

INFLATABLE RESTRAINT SIDE IMPACT MODULE REPLACEMENT - FRONT

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 and SIR Disabling and Enabling Zone 6.

CAUTION:
- Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.
- Refer to SIR Caution in Service Precautions.
- Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:
- The seat cushion frame
- The seat recliner, if equipped
- The seat adjuster
- The seat back frame
- Failure to do so may cause future personal injury.

2. Remove the seat assembly from the vehicle.
3. Remove the seat back cover and pad to expose the inflator module mounting bolts and the wiring harness.
4. Remove the front seat back panel.
5. Remove the 2 screws that secure the inflatable side impact module to the seat back frame.
6. Remove the SIR wiring harness from the seat.
7. Remove the side impact module.
8. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.

INSTALLATION PROCEDURE




1. Install the SIR wiring harness to the seat.
2. Install the inflatable side impact module to the seat back frame with the 2 screws.

Tighten the inflatable side impact module screws to 6 N.m (55 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the front seat back panel.
4. Install the seat back cover and pad.
5. Install the seat assembly to the vehicle.
6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 and SIR Disabling and Enabling Zone 6.