Generator Replacement

GENERATOR REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Raise the vehicle. Refer to Vehicle Lifting.
2. Disconnect the negative battery cable.
3. Lower the vehicle.
4. Remove the accessory drive belt.
5. If necessary, remove the engine sight shield.




6. Disconnect the generator electrical connector (3).




7. Remove the generator cable from the generator, perform the following:
1. Slide the boot down revealing the terminal stud.
2. Remove the generator cable nut from the terminal stud.
3. Remove the generator cable.




8. Remove the generator bolts.
9. Remove the generator.

INSTALLATION PROCEDURE




1. Install the generator.
2. Install the generator bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the generator bolts to 50 N.m (37 lb ft).




3. Install the generator cable to the generator, perform the following:
1. Install the generator cable.
2. Install the generator cable nut to the terminal stud.

Tighten the generator cable nut to 9 N.m (80 lb in).

3. Slide the boot over the terminal stud.




4. Connect the generator electrical connector (3).
5. If necessary, install the engine sight shield.
6. Install the accessory drive belt.
7. Raise the vehicle.
8. Connect the negative battery cable.
9. Lower the vehicle.