Control Lever Handle Assembly Replacement

Control Lever Handle Assembly Replacement

Removal Procedure
1. Remove the console assembly.

2. Important: Position the control lever in 3rd gear to gain access to the retaining bolts.

Remove the retaining bolts for the control lever handle assembly.
3. Remove the control lever handle assembly.

Installation Procedure
1. Position the control lever handle on the shift control assembly.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the retaining bolts for the control lever handle.

Tighten the retaining bolts to 25 Nm (18 ft. lbs.).

3. Install the console assembly.