Power Window Motor: Service and Repair

WINDOW REGULATOR MOTOR REPLACEMENT - DOOR

REMOVAL PROCEDURE
1. Raise the window.
2. Remove the door trim panel.
3. Remove the front door water deflector.
4. Remove the door window.




5. Disconnect the wiring harness from the door window regulator motor.




6. Remove the 4 bolts (1) from the door window regulator.
7. Separate the door window regulator motor from the cable housing by wiggling the door window regulator motor.Observe the orientation of the door window regulator motor.

IMPORTANT: Do not allow the cable gear to come out of the housing. A failure will result with the cable coming off the spool.




8. Remove the door window regulator motor bolts (1) from the door regulator.

INSTALLATION PROCEDURE

1. Install the door window regulator motor to the cable housing by wiggling it into place.

IMPORTANT: Do not allow the cable gear to come out of the housing. A failure will result with the cable coming off the spool.




2. Install the door window regulator motor bolts (1) to the door regulator.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 5 N.m (44 lb in).

3. Install the door window regulator and motor in the vehicle.




4. Install the 4 bolts (1) to the door window regulator

Tighten the bolts to 25 N.m (18 lb ft).

5. Install the door window.




6. Connect the wiring harness to the door window regulator motor.
7. Connect the wire connector to the switch to inspect the operation of the window.After inspection disconnect the wiring harness and continue the installation.
8. Install the front door water deflector.
9. Install the side front door trim panel.