70. Input Speed Sensor Installation

Input Speed Sensor Installation





1. Inspect the input speed sensor (ISS) assembly (250) for the following conditions:
^ Cracked or damaged housing
^ Worn or missing harness brackets
^ Damaged or worn wining or electrical connector
^ Loose, missing or damaged mounting bolt insert





2. Remove the input speed sensor (ISS) O-ring (249) and discard.
3. Lubricate NEW O-ring (249) with transmission fluid and position in the ISS O-ring groove.
4. Insert the ISS (250) into oil pump ISS bore and fully seat.
5. Align ISS bolt insert with oil pump mounting bolt hole.

Notice: Refer to Fastener Notice.

6. Install bolt (247).
^ Tighten the bolt to 9 - 11 Nm (6.6 - 8.1 lb ft).





7. Route the ISS assembly (250) wire harness as shown. Install harness bracket #1 and #2 in the locations shown. Ensure the wire harness lays flat against the pump housing.