B3006

DTC B3006

Circuit Description

The body control module (BCM) monitors the voltage input of the hood ajar switch open signal circuit and the hood ajar switch closed signal circuit. The 2 separate voltage signals should never be the same voltage with the hood opened or closed. If the 2 voltage signal should have the same voltage value DTC B3006 will set.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC B3006 Hood Ajar Circuit

This vehicle has DTCs which include DTC symptoms. For more information on DTC symptoms, refer to DTC Symptom Description.






Conditions for Running the DTC

This DTC shall run when the Run/Crank Relay is enabled.

Conditions for Setting the DTC

B3006 01

Sets if both signal circuits are at a high voltage state.

B3006 02

Sets if both signal circuits are at a low voltage state.

Action Taken When the DTC Sets

The BCM will disable the remote start function.

Conditions for Clearing the DTC

The DTC will clear when conditions for setting the DTC have been repaired.

Test Description

Step 1 - Step 11:

Step 12:

The number below refers to the step number on the diagnostic table.
2. The hood ajar switch is part of the hood latch assembly.