B1424
DTC B1424
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptor
DTC B1424 00
- Device Voltage Low - TDM
Diagnostic Fault Information
Circuit/System Description
The theft deterrent module (TDM) monitors the battery positive (B+) voltage available to it. If the voltage at the TDM is between 6-9 volts, and the voltage being reported by a serial data message is greater than 9 volts, then DTC B1424 00 sets.
Conditions for Running the DTC
* The ignition switch is in Accessory or Run.
* This diagnostic runs every 100 milliseconds.
Conditions for Setting the DTC
* Voltage at the TDM B+ circuit is between 6-9 volts.
* Reported battery voltage received via serial data is valid and is greater than 9 volts.
* The above conditions have been met for 2 seconds.
Action Taken When the DTC Sets
The security indicator turns ON.
Conditions for Clearing the DTC
* A current DTC clears when the battery voltage at the TDM is greater than 9 volts, or if the voltage reported by serial data is less than 9 volts.
* A history DTC clears after 100 consecutive ignition cycles, if no failures are reported by this diagnostic.
Diagnostic Aids
* A low voltage DTC in multiple modules indicates a concern in the charging system.
* Verify that the ground terminal G201 is clean and tight.
Reference Information
Schematic Reference
* Immobilizer Schematics (Immobilizer Schematics)
* Starting and Charging Schematics ([1][2]Electrical Diagrams)
* Ground Distribution Schematics (Ground Distribution Diagrams)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
* Immobilizer Description and Operation (Immobilizer Description and Operation)
* Charging System Description and Operation (Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Testing
1. Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6 and 15.0 volts.
• If not within the specified range, refer to Charging System Test (Charging System Test).
2. Ignition OFF, disconnect the harness connector at the TDM.
3. Ignition OFF, test for less than 5 ohms between the ground circuit terminal 3 and ground.
• If greater than the specified range, test the ground circuit for an open/high resistance.
4. Verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.
• If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
5. If all circuits tests normal, replace the TDM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for TDM replacement, set up, and programming.