C0000

DTC C0000

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0000 71
- Vehicle Speed Information Circuit

Circuit/System Description

The power steering control module (PSCM) receives a vehicle speed message from the engine control module (ECM) via the serial data circuit. The PSCM uses this vehicle speed message, and other inputs, to determine the desired amount of steering assist. At lower speeds, more assist is provided for easy turning during parking maneuvers. At higher speeds, less assist is provided for improved road feel and directional stability.

Conditions for Running the DTC

* The ignition is ON.
* DTC U2100, U2105, 2107, or U2109 is not set.
* Power steering system voltage is between 9-16 volts.

Conditions for Setting the DTC

The PSCM receives an invalid vehicle speed message from the ECM.

Action Taken When the DTC Sets

* DTC C0000 71 is stored in memory.
* The DIC displays the POWER STEERING warning message.
* Steering assist is set to a default level.

Conditions for Clearing the DTC

* A current DTC will clear when the malfunction is no longer present.
* A history DTC will clear after 100 consecutive malfunction-free ignition cycles.

Diagnostic Aids

This DTC is for information only. As an aid to the technician, this DTC indicates that their are no problems in the PSCM. The ECM should be checked for a possible fault.

Reference Information
Schematic Reference

Power Steering Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Power Steering System Description and Operation (Non-Turbo) (Description and Operation)Power Steering System Description and Operation (Turbo) (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

1. Verify that no DTCs are set in the ECM.

• If DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (Diagnostic Trouble Code Descriptions).