Part 4
78. If equipped with a automatic transaxle perform the following steps, install the engine harness ground terminal (3) to the stud.
79. Install the positive/negative cable (2) terminal to the stud.
80. Install the positive/negative battery cable ground nut (1).
Tighten the nut to 10 Nm (89 lb in).
81. Connect the following electrical connectors:
* CKP sensor (4)
* Oil pressure sensor (5)
* Knock sensor (6)
82. Install the starter. Refer to Starter Motor Replacement (Service and Repair).
83. Install the engine harness clips (2, 4) to the intake manifold.
84. Lower the vehicle.
85. Install the engine harness clip (1) to the oil level indicator tube bracket.
86. Install the engine harness clip (1) to the transaxle stud.
87. Install the engine harness clip nut (2).
Tighten the nut to 10 Nm (89 lb in).
88. Install the engine harness clips (1, 2) to the camshaft cover.
89. Connect the intake (2) and exhaust (1) camshaft position actuator electrical connectors.
90. Connect the ignition coils electrical connectors (3).
91. Connect the following electrical connectors:
* TAC (1)
* MAP sensor
* Fuel injector harness (2)
* Generator (3)
92. Install the brake booster vacuum hose to the intake manifold.
93. Position the brake booster vacuum hose clamp at the intake manifold.
94. Position the engine coolant heater cord, if equipped.
95. Install the engine coolant heater cord straps to the engine harness, if equipped.
96. Connect the engine coolant heater cord, if equipped.
97. If the vehicle is not equipped with a engine oil cooler, install the radiator outlet hose to the engine.
98. Position the radiator outlet hose clamp at the engine.
99. If the vehicle is equipped with a engine oil cooler perform the following steps, install the radiator outlet hose to the oil cooler.
100. Install the radiator outlet hose to the water outlet.
101. Position the radiator outlet hose clamp (2) at the oil cooler.
102. Position the radiator outlet hose clamp (1) at the water outlet.
103. Install the heater inlet and outlet hoses to the thermostat housing.
104. Position the heater inlet and outlet hose clamps at the thermostat housing.
105. Connect the intake (2) and exhaust (1) CMP sensor electrical connectors.
106. Install the engine harness clip (1) to the EVAP purge solenoid bracket.
107. Connect the EVAP purge solenoid electrical connector (1).
108. Install the radiator inlet hose to the engine.
109. Position the radiator inlet hose clamp at the engine.
110. Position and install the ECM bracket to the studs.
111. Install the ECM bracket nuts (1) and bolts (2).
* Tighten the bolts to 25 Nm (18 lb ft).
* Tighten the nuts to 10 Nm (89 lb in).
112. Install the positive battery cable terminal (1) to the junction block stud.