Liftgate Ajar Indicator Malfunction
Liftgate Ajar Indicator Malfunction
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
The body control module (BCM) receives an input from the liftgate ajar switch. The ajar switch is normally open when the liftgate is fully closed. When the liftgate is opened, the ajar switch contacts close providing a path to ground. The driver information center (DIC) located at the bottom of the instrument panel cluster (IPC), illuminates the REAR ACCESS OPEN message when the liftgate is open. The IPC receives a serial data message from the BCM indicating the liftgate ajar status.
Reference Information
Schematic Reference
Release Systems Schematics Release Systems Schematics
Connector End View Reference
Component Connector End Views Connector End Views By Name
Description and Operation
Door Ajar Indicator Description and Operation Description and Operation
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Scan Tool Reference
Control Module References Programming and Relearningfor scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool Rear Closure Ajar Sw. parameter and the DIC display while opening and closing the liftgate. The parameter should change from Inactive to Active and the REAR ACCESS OPEN message should turn ON and OFF.
If the parameter changes from Inactive to Active but the DIC REAR ACCESS OPEN display is always ON or always OFF, replace the IPC.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the liftgate latch assembly.
2. Test for less than 1 ohm between the ground circuit terminal 5 and ground.
• If greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition ON, verify the scan tool Rear Closure Ajar Sw parameter Inactive.
• If not the specified value, test the signal circuit terminal 6 for a short to ground. If the circuit tests normal, replace the BCM.
4. Install a 3A fused jumper wire between the signal circuit terminal 6 and ground. Verify the scan tool Rear Closure Ajar Sw parameter is Active.
• If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal replace the BCM.
5. If all circuits test normal, test or replace the liftgate latch assembly.
Component Testing
1. Ignition OFF, disconnect the harness connector at the liftgate latch assembly.
2. Test for infinite resistance between the signal terminal 6 and the ground terminal 5 with the switch in the open position.
• If not the specified value, replace the liftgate latch assembly.
3. Test for less than 2 ohms between the signal terminal 6 and the ground terminal 5 with the switch in the closed position.
• If greater than the specified range, replace the liftgate latch assembly.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.
Control Module References Programming and Relearningfor BCM or IPC replacement, setup and programming