Front Suspension

Stabilizer Shaft Link Replacement

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the stabilizer shaft nut from the link bolt.
3. Remove the stabilizer shaft link bolt.
4. Remove the stabilizer shaft link insulators and spacers.
5. Inspect all of the parts for wear and damage.

Installation Procedure




1. Install the stabilizer shaft link insulators and spacers.
2. Perform the following procedure before installing the stabilizer shaft link bolts.

* Remove all traces of the original adhesive patch.
* Apply Threadlocker GM P/N 12345382 or BLUE LOCTITE(TM) #242 on the threads of the bolts.

3. Install the stabilizer shaft link bolts.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the stabilizer shaft nut to the link bolt and tighten to 11 Nm (97 lb in).
5. Remove the safety stands.
6. Lower the vehicle.