B1004

DTC B1004

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC B1004
- Keep Alive Memory (KAM) Reset

Circuit/System Description

The internal fault detection is handled inside the control module.

Conditions for Running the DTC

The control module microprocessor must be active/awake.

Conditions for Setting the DTC

The KAM in the control module has been reset. It is a normal occurrence when battery positive voltage or ground is removed from the module, such as a battery disconnect.

Action Taken When the DTC Sets

The microprocessor reverts back to the base programmed critical operating data until new data is learned and stored in KAM.

Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.
* A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Reference Information
Schematic Reference

Data Communication Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Data Link Communications Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool References

Control Module References (Programming and Relearning)for Scan Tool Information

Circuit/System Verification

Verify that DTC B1004 is not set.

If the DTC is set, perform the setup procedure on the applicable control module, if the DTC resets replace the module.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning)for control module replacement, setup, and programming