Battery Positive Cable Replacement (TP2)

Battery Positive Cable Replacement (TP2)

Removal Procedure

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (TP2) (Service and Repair).




2. Remove the underhood fuse block cover (1).
3. Lift the fuse block retainers (2) from the locked position and rotate the retainers to the open position.
4. Reposition the fuse block and remove the battery positive connector (3) from the underhood fuse block base.




5. Remove the battery positive cable connector (1) from the auxiliary relay.
6. Remove the battery positive cable nut (2) and terminal (3) from the auxiliary relay.




7. Remove the battery positive terminal nuts (1) and (2), from the mega fuse holder.
8. Disconnect the engine harness connector (4) from the battery positive cable.




9. Remove the retaining nuts (1) and cable clips (2), securing the cable to the upper plenum.




10. Remove the battery positive cable from the vehicle.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the battery positive cable (3) to the battery mega fuse holder with nuts (1) and (2). Tighten the nuts to 10 Nm (89 lb in)
2. Connect the engine harness connector (4) to the battery positive cable.




3. Install the battery positive cable to the studs on the upper plenum.




4. Install the cable retainers (2) and tighten the nuts (1) to 10 Nm (89 lb in)




5. Install the battery positive cable connector (3) to the underhood fuse block.
6. Ensure that the underhood fuse block retainers (2) are in the open position.
7. Position and engage the junction block to the 4 bracket pivots, push the retainers (2) down into the locked position.
8. Install the underhood fuse block cover.
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (TP2) (Service and Repair).