P079D
DTC P079D
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC P079D
- Transmission Clutch 4 Slip Detected
Circuit/System Description
The transmission control module monitors the 1-3 clutch slip speed when the 1-3 clutch is applied. The 1-3 clutch is displayed as Clutch 4 on the scan tool. The transmission control module is part of the control solenoid valve assembly and is not serviced separately.
Conditions for Running the DTC
The clutch pressure control solenoid 4 commanded pressure is 1800 kPa (261 psi).
Conditions for Setting the DTC
The transmission control module detects the 1-3 clutch slip speed is greater than 100 RPM for.3 seconds.
Action Taken When the DTC Sets
* P079D is a Type B DTC.
* The transmission control module inhibits gear 1 and gear 3.
Conditions for Clearing the DTC
P079D is a Type B DTC.
Diagnostic Aids
When attempting to set transmission performance DTCs, observe the Freeze Frame and Failure Records to assist in duplicating the failure conditions. Ensure the transmission fluid level is correct and there are no leaks. If there are any other transmission DTCs set, diagnose those first.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Powertrain Diagnostic Trouble Code (DTC) Type Definitions)
Circuit/System Verification
1. Verify that DTCs P0721, P0722, P0723, P0966, P0967, P0969, P0970, P0971, P0973, P0974, P0976, P0977, P2720, P2721, P2728, P2729, or P2730 are not set.
• If the DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (Diagnostic Trouble Code (DTC) List - Vehicle).
2. Perform the Transmission Fluid Level and Condition Check (Transmission Fluid Level and Condition Check) to verify correct fluid level.
3. Perform the Line Pressure Check (Line Pressure Check) to verify correct oil pressure.
4. Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (Control Solenoid Valve and Transmission Control Module Assembly Inspection) to verify Q8 control solenoid valve assembly condition.
5. Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test (Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test) to verify Q8 control solenoid valve assembly function.
6. Inspect the trans fluid pump ball check valve for possible sticking or damage.
• If you found a concern with this check ball, repair the concern.
7. Inspect the hybrid low, 1-2 clutch boost valve assembly for sticking or damage.
• If you found a concern with the hybrid low, 1-2 clutch boost valve assembly, repair or replace the valve or valve body.
8. Inspect the 1-3 clutch assembly for a slipping or damaged condition.
• If you found a 1-3 clutch assembly concern, repair or replace the 1-3 clutch assembly as necessary.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Control Valve Assembly Disassemble ()for Valve Body inspection procedures.
* Control Valve Upper Body Replacement (2ML70 - Automatic Transmission)for Control Valve Body replacement.
* 1-3 Clutch Housing Overhaul ()for 1-3 Clutch Assembly repair or replacement.
* Control Module References (Control Module References)for Control Solenoid Valve Assembly replacement, programming and setup.