MP 1625/1626-NQF - Transfer Case

DTC C0569

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0569 4B
- System Configuration Error Calibration Not Learned

Circuit/System Description

* This is an internal fault detection of the transfer case shift control module (TCCM). No external circuits are involved.
* This DTC is set anytime a transfer case shift control module (TCCM) is replaced or reprogrammed.
* The automatic transfer case (ATC) motor learn procedure must be performed to erase this DTC. The motor learn procedure allows the module to learn where the shift rails are located.

Conditions for Running the DTC

* Ignition ON.
* System voltage 10.5-18 V.

Conditions for Setting the DTC

The ATC motor learn procedure for a new or reprogrammed TCCM has not been performed.

Action Taken When the DTC Sets

* Mode shifting is disabled until the ATC motor learn procedure has been performed.
* The SERVICE 4WD indicator illuminates.
* No mode position LED's illuminated.

Conditions for Clearing the DTC

The TCCM clears the DTC once the ATC motor learn procedure has been successfully performed.

Reference Information
Schematic Reference

Transfer Case Control Schematics (MP 1625/1626-NQF - Transfer Case)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Control Module References) for scan tool information.

Circuit/System Verification

1. Engine running. Let the engine run for at least 1 minute.
2. Ignition OFF for at least 30 seconds to allow for the complete shutdown of the TCCM.
3. Ignition ON, verify that DTC C0569 is not set.

• If DTC C0569 sets. perform the ATC motor learn procedure. Refer to Transfer Case High/Low Clutch Reset (Transfer Case High/Low Clutch Reset).

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Transfer Case High/Low Clutch Reset (Transfer Case High/Low Clutch Reset)