109. Four-Wheel-Drive Output Shaft Retaining Nut Installation

Four-Wheel-Drive Output Shaft Retaining Nut Installation

Special Tools

J 43769 - Spanner Nut Wrench - 4WD

For equivalent regional tools, refer to Special Tools (Allison - Automatic Transmission).




1. The fullest clockwise position of the manual shift shaft is Park (P), which engages the park pawl.
2. Using a wrench on the manual shift shaft flats (1), rotate the shaft to the fullest clockwise position.




3. Ensure the park pawl is engaged.
4. Install the J 43769 - wrench (1) onto the output shaft retaining nut, 4WD (2).

Caution: Refer to Fastener Caution (Fastener Caution).

5. Using the J 43769 - wrench (1), install a new output shaft retaining nut, 4WD (2) onto the output shaft (3). Tighten the nut to 61 Nm (45 lb ft).





Note: The Neutral (N) position of the manual shift shaft is 2 detent positions counterclockwise from the fullest clockwise position.

6. Using a wrench on the manual shift shaft flats (1), rotate the shaft to the fullest clockwise position.
7. Rotate the manual shift shaft counterclockwise 2 detent positions.
8. Make sure the park pawl is disengaged.