Operation CHARM: Car repair manuals for everyone.

Antilock Brake System




DTC C0880, C12E5, or C120F

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.

DTC Descriptors
DTC C0880 00
- Device Voltage Reference Output Circuit

DTC C12E5 00
- Brake Pedal Position Sensor Reference Circuit

DTC C0880 02
- Device Voltage Reference Output Circuit Short to Ground

DTC C120F 00
- Device Voltage Reference Output Circuit Short to Ground

Diagnostic Fault Information






Circuit/System Description

The electronic brake control module (EBCM) supplies a shared 5 volt reference to the brake master cylinder piston position sensor, steering angle sensor and brake master cylinder piston position sensor.

Conditions for Running the DTC

* Ignition ON.
* The ignition voltage is greater than 10 volts.

Conditions for Setting the DTC

The EBCM detects the voltage on the 5 V reference circuit to the brake master cylinder piston position sensor, steering angle sensor and brake master cylinder piston position sensor is less than 4.8 V or greater than 5.2 V.

Action Taken When the DTC Sets

* The EBCM disables the antilock brake system (ABS), traction control and the vehicle stability enhancement system for the duration of the ignition cycle.
* A driver information center message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics Electrical Diagrams
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation

ABS Description and Operation ABS Hybrid
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearningfor scan tool information

Circuit/System Testing

1. Verify DTC C0455 is not set.

If DTC is set, refer to DTC C0455 C0455.

2. Verify DTC C0277 is not set.

If DTC is set, refer to DTC C0277, C120C, C129A, C129B, C129D, C129E, C12B1, or C12F8 Antilock Brake System.

3. Ignition OFF, disconnect the harness connector at the electronic brake control position sensor.
4. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 2 and ground.

If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.

If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Programming and Relearningfor EBCM replacement, programming and setup