Operation CHARM: Car repair manuals for everyone.

C0256




DTC C0256, C12E6, or C12E7

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.

DTC Descriptors
DTC C0256 04
- Valve Relay Contact Circuit Open

DTC C12E6
- Valve Relay Contact Circuit Open

DTC C0256 0E
- Valve Relay Contact Circuit Resistance Below Threshold

DTC C12E7
- Valve Relay Contact Circuit Resistance Below Threshold

Circuit/System Description

The base brake solenoid relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids.

Conditions for Running the DTC

* Ignition ON.
* The ignition voltage is greater than 10 V.

Conditions for Setting the DTC

C0256 04 or C12E6
* The EBCM detects an open in the circuits to the solenoid valve relay.
* The EBCM detects a stuck open solenoid valve relay.

C0256 0E or C12E7
* The EBCM detects an short to battery in the circuits to the solenoid valve relay.
* The EBCM detects a stuck closed solenoid valve relay.

Action Taken When the DTC Sets

* The EBCM disables the antilock brake system (ABS) and the vehicle stability enhancement system (VSES) for the duration of the ignition cycle.
* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics Electrical Diagrams
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation

ABS Description and Operation ABS Hybrid
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearningfor scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the EBCM.
2. Test for less than 1 ohm between the ground circuits listed below and ground.

* Terminal 13
* Terminal 38

If greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground.

* Terminal 1
* Terminal 25

If the test lamp does not illuminate, test the appropriate circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, replace the BPMV.

4. If all circuits test normal, replace the BPMV and verify DTC does not reset. If the DTC resets, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Brake Pressure Modulator Valve Replacement Service and Repair
* Control Module References Programming and Relearningfor EBCM replacement, setup, and programming