P0C19

DTC P0C19

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.

DTC Descriptor
DTC P0C19
- Drive Motor 1 Torque Delivered Performance

Circuit/System Description

Drive motor 1 controlled by motor control module 1. The motor control module constantly monitors the requested torque and the delivered torque of its respective drive motor generator. Motor control module 1 is part of the drive motor generator power inverter module and is not serviced separately.

Conditions for Running the DTC

* The system voltage is 8-18 V.
* Drive motor generator is commanded to develop torque.

Conditions for Setting the DTC

The motor control 1 module has detected that drive motor 1 torque is not being delivered as expected.

Action Taken When the DTC Sets

* DTC P0C19 is a Type A DTC.
* The hybrid powertrain control module commands the battery energy control module to open the high voltage contactor relays.

Conditions for Clearing the DTC

DTC P0C19 is a Type A DTC.

Diagnostic Aids

Because the engine and drive motor 1 are mechanically connected through a planetary gear set, an engine condition that requires drive motor 1 to consume excessive current while trying to rotate the engine may cause this DTC to set such as:

* Extreme acceleration from stop may cause this DTC to be set in history.
* Extreme braking during regeneration may cause this DTC to be set in history.
* Seized or binding engine
* Seized or binding accessory drive belt

Reference Information
DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification

1. Verify the engine is not seized or binding.

• If the engine is seized or binding, refer to Symptoms - Engine Mechanical Symptoms - Engine Mechanical.

2. If the DTC is set, program the T6 drive motor generator power inverter module. If the DTC resets, replace the T6 drive motor generator power inverter module.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Programming and Relearningfor Drive Motor Generator Power Inverter Module replacement, setup and programming.