Transfer Case Shift Control Switch Indicator Inoperative - One or More

Transfer Case Shift Control Switch Indicator Inoperative - One or More

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The indicator circuits consists of an interior lights dimming circuit and an indicator control circuit. When a mode has been selected, current is supplied to the indicator by the interior lights dimming circuit, traveling through the indicator LED, at which time the transfer case shift control module supplies the ground through the indicator lamp control circuit.

Reference Information
Schematic Reference

Transfer Case Control Schematics MP 3023/3024-NQH - Transfer Case
Connector End View Reference

Component Connector End Views 1-2 Shift Solenoid (SS) Valve (M30)
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information.

Diagnostic Aids

A short to ground on the indicator control circuit will cause the indicator to remain on at all times.

Circuit/System Testing

1. With in ignition off disconnect connector X1 at the transfer case control module and turn the ignition on. With a jumper wire probe the indicator control circuit of the affected indicator and take the other end of the jumper to ground. If the indicator comes on then replace the transfer case control module, program, and perform the motor learn procedure
2. If the affected indicator did not come on then check the indicator control circuit for an open or high resistance. If the circuit checks good then replace the transfer case shift control switch.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Transfer Case Shift Control Switch Replacement (Without SLT) Transfer Case Shift Control Switch Replacement (Without SLT)Transfer Case Shift Control Switch Replacement (With SLT) Transfer Case Shift Control Switch Replacement (With SLT)
* Control Module References Control Module References for TCSCM replacement, setup, and programming
* Transfer Case High/Low Clutch Reset Transfer Case High/Low Clutch Reset